Alternative Tyco / Kilovac the EV200. See product comparison.
EPIC ® Seal-specific ceramic seal technology, the rated operating temperature up to 175 ℃ - with the space program uses the same advanced technology, lower the pass
Have over-current at the time of the fire or the risk of hot-melt.
Fully enclosed - designed to meet UL1604 standard No. 2 Group I level and two and dangerous places for the three standards, short-term 30-minute immersion IP67 standards
SAE J1171 external standard flame-retardant, flame retardant in the combustible gas in the ISO8846 standard.
Choice of high-performance dual-coil DC - very low power 12VDC or 24VDC coil, no electromagnetic radiation, the system control loop without the interference, noise-free launch
Sound, our GX200 dual coil, after the completion of actions from a coil to make contact in low-power state to maintain incentives.
Non-exposed coil circuit - the GX200, we can be in any environment, and even underwater work - not as Tyco's EV200, it inhibited electrical counter electromotive force
Road exposure, it is difficult to work in harsh conditions.
Built-in DC over-voltage suppression coil - to save an additional coil to inhibit the consumption of engineering time and parts cost.
Built-in power connection insurance cover - no need to use locking nut can get a reliable connection, in the case do not need to be easily dismantled.
Requirements in full compliance with the ROHS environmental protection-GX200 more, EV200 not in full compliance with ROHS requirements.

In order to compare the GX200 with the Tyco / Kilovac the EV200, we set 85 ° C in the GX200 environment, connecting cables 400KCmil,
End leads to the highest temperature of 150 ° C, than the UL of 125 ° C higher than the number of high-temperature wire insulation. At the highest temperature of 150 ° C under the conditions of
Continuous current of more than 400A, the user must use a cable or bus bars will be directed away from the heat, or reduce the ambient temperature. For UL rating, see under
Surface "UL rated under the conditions of breaking capacity", with regard to contact rating of more information, see the product comparison.

1 / Because the contactor drive coil resistance with temperature changes in the temperature of 25 ℃ lower than the maximum voltage of the coil will be lower than the table value, higher than 25 ℃
Than the high table.
2 / There are two coil contactor. At the same time, the role of time in the smoke at about the time of 75ms, one coil will be disconnected from the circuit. To retain the coil to
Allows for contact to meet their performance parameters to maintain a continuous current. This can be used in pulse-width modulation circuit is not the case so that the minimum power consumption, the latter
Would be caused by electromagnetic radiation, resulting in interference control loop system.
3 / Because the contactor drive coil resistance will change with temperature, while the nominal coil voltage in accordance with the input current to maintain the current, designed to maintain power,
At a temperature lower than 25 ℃ when the actual maximum coil current / power value than the table values higher than 25 ℃ lower than the table.
4 / in the double-coil contactor to pull-in voltage test, not the slow rise in voltage, but must be suddenly added to the maximum pull-in voltage or current to
Otherwise, contact will not pull-in.
5 / Because the contactor drive coil resistance with temperature changes, at a temperature lower than 25 ℃ when the pull-in voltage to maintain the voltage, release voltage than the number of table
Values lower than 25 ℃ higher than the high table.
6 / These DC coil with built-suppression coil. Additional new coil will be extended by inhibiting the release of time, shorten the product life or reduce the maximum current disconnect. Such as
Fruit need to reverse a lower electromotive force, please contact us.